Napoleon Grills P405 PEDESTAL Bedienungsanleitung PDF herunterladen (Seite 9)

TROUBLESHOOTING

Problem Possible Causes Solution

Low heat / Low flame when

valve turned to high.

For propane - improper lighting

procedure.

Ensure lighting procedure is followed carefully. All gas grill

valves must be in the off position when the tank valve is

turned on. Turn tank on slowly to allow pressure to equalize.

See lighting instructions.

For natural gas - undersized

supply line.

Pipe must be sized according to installation code.

For both gases - improper

preheating.

Pre-heat grill with main burners on high for 10 to 15 minutes.

Excessive flare-ups/uneven

heat.

Sear plates installed incorrectly. Ensure sear plates are installed correctly. The archs without

slots should be located directly above the left and right

burners. When the sear plates are installed correctly, six of

the eight slots should be in valleys.

Improper pre-heating. Pre-heat grill with main burners on high for 10 to 15 minutes.

Excessive grease and ash build

up on sear plates and in drip

pan.

Clean sear plates and drip pan regularly. Do not line base

with aluminum foil. Refer to cleaning instructions.

Burners burn with yellow

flame, accompanied by the

smell of gas.

Possible spider web or other

debris, or improper air shutter

adjustment.

Thoroughly clean burner by removing. See general

maintenance instructions. Open air shutter slightly according

to combustion air adjustment instructions.

Burner will not light with the

igniter, but will light with a

match.

Dead battery / or installed

incorrectly.

Replace with heavy duty 'AAA' battery. Install with positive

terminal down.

Loose electrode wire. Check that electrode wire is firmly pushed onto the terminal

on the back of the igniter.

Wrong replacement igniter. One spark systems must use a one spark igniter.

Improper gap at electrode tip. Ensure that the collector box is tight, and the gap between the

electrode end and the collector box is between 1/8 - 3/16".

The gap can be adjusted by bending the box in or out.

Humming regulator.

Normal occurance on hot days. This is not a defect. It is caused by internal vibrations in the

regulator, and does not affect the performance or safety of the

gas grill.

Burners will not crosslight

each other.

Plugged ports along back of

burner.

Clean burner ports. See burner maintenance instructions.

Improper air shutter adjustment. Close air shutter slightly according to combustion air

adjustment instructions.

Flames lift away from

burner, accompanied by the

smell of gas, and possibly

difficulties in lighting.

Lifting flames on burner. Close air shutter slightly - see previous problem

"Paint" appears to be

peeling inside lid or hood.

Grease build up on inside

surfaces.

This is not a defect. The peeling is caused by hardened

grease, which dries into paint-like shards, that will flake off.

Regular cleaning will prevent this. See cleaning instructions.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Napoleon Grills P405 PEDESTAL Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Barbrque & Grills Napoleon Grills P405 PEDESTAL