Napoleon Grills Gourmet Grill Bedienungsanleitung PDF herunterladen

BUILT-IN UNIT INSTRUCTION GUIDE

N415-0175 / MAR 04/08

Please use this manual in conjunction with your main manual to properly assemble your built-in grill. Refer to

the main manual for operating, cleaning, and maintenance instructions. This grill is designed for NON-COM-

BUSTIBLE enclosures only, and must be installed and serviced by a qualified installer to local codes.

BUILT IN PROPANE GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as

shown in the built-in instructions. A flexible metal connector is included to simplify the installation of the unit. Connect this connector

to the 3/8” flare fitting on the end of the manifold. Connect the other end of the connector to the gas piping. Ensure that the

connector does not pass through a wall, floor, ceiling or partition, and is protected from damage. Do not use hose to connect the

unit. It must be connected with either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply

with CAN B149.1 Natural Gas and Propane installation code in Canada, or to the National Fuel Gas code, ANSI Z223.1 in the United

States. The minimum recommended piping size is NPS 1/2" for rigid pipe, and 1/2" OD for copper tubing (based on a 20 ft run).

Longer runs may require larger sizes to conform with local codes or to conform with CAN B149.1. Propane Gas Installation Code in

Canada or to the National Fuel Gas Code, ANSI Z223.1 in the United States. The gas supply must be connected to the 3/8” flare

elbow fitting located under the right hand side of the control panel. If installing a side burner, a separate line must be branched off to

the side burner unit and enter the side burner opening at the specified location. If the enclosure is to house a propane cylinder, the

tank portion of the enclosure must be ventilated according to local codes, and must not have communication with the cavity used to

enclose the gas grill. A propane tank can not be stored below the gas grill.

BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as

shown in the built-in instructions. A flexible metal connector is included to simplify the installation of the unit. Connect this connector

to the 3/8” flare fitting on the end of the manifold. Connect the other end of the connector to the gas piping. Ensure that the connector

does not pass through a wall, floor, ceiling or partition, and is protected from damage. Do not use hose to connect the unit. It must

be connected with either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply with CAN

B149.1 Natural Gas and Propane Installation Code in Canada, or to the National Fuel Gas Code, ANSI Z223.1 in the United States.

The minimum recommended piping size is NPS 1/2" for rigid pipe, and 5/8" OD for copper tubing (based on a 20 ft run). Longer

runs may require larger sizes to conform with local codes or to conform with CAN B149.1. Natural Gas Installation Code in Canada

or to the National Fuel Gas Code, ANSI Z223.1 in the United States.

Built in units are supplied with a drip pan which holds only a minimal amount of grease. To prevent grease fires, the pan must

be cleaned after each use.

SERIAL #______________________

DANGER: READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING GRILL. FAILURE TO FOLLOW

THESE INSTRUCTIONS EXACTLY COULD RESULT IN A FIRE CAUSING SERIOUS INJURY OR DEATH.

THE ENTIRE INSTALLATION MUST BE LEAK TESTED BEFORE OPERATING THE GRILL.

1 2 3 4 5 6 ... 17 18

Inhaltsverzeichnis

Seite 1 - N415-0175 / MAR 04/08

BUILT-IN UNIT INSTRUCTION GUIDEN415-0175 / MAR 04/08Please use this manual in conjunction with your main manual to properly assemble your built-in gri

Seite 2 - NON-COMBUSTIBLE MATERIAL

SERIAL #______________________GUIDE D’INSTRUCTIONS POUR LES GRILS ENCASTRÉSVeuillez utiliser ce guide conjointement avec votre manuel principal pour a

Seite 3

BIPT450 29 1/2” 20 5/8” 8 7/8”BIPT600 37 3/4” 20 5/8” 8 7/8”BIPT750 49 3/4” 20 5/8” 9 5/8”BIU405 271/2” 16 3/4” 12”

Seite 4

HLPLE CADRE DES ACCESSOIRESCHEVAUCHE L’OUVERTURE DE 1 ½”SUR LES QUATRE CÔTÉS.N° de pièceDescriptionIllustrationLHN370-0070Porte horizontale peinteN370

Seite 5

1. INSTRUCTIONS POUR LE GRIL ENCASTRÉ BIPT450N010-0568N715-0080N080-0213N080-0213N570-0026Ce gril est conçu pour des cabinets INCOMBUSTIBLES OU EN MAÇ

Seite 6

2. INSTRUCTIONS POUR LE GRIL ENCASTRÉ BIPT600N080-0213N715-0081N010-0569N080-0213N570-0026N380-0009N051-0001Ce gril est conçu pour des cabinets INCOMB

Seite 7

3. INSTRUCTIONS POUR LE GRIL ENCASTRÉ BIPT750N715-0082N010-0570N080-0213N570-0026N380-0009N051-0001N080-0213Ce gril est conçu pour des cabinets INCOM

Seite 8 - N280-0004 (STN STL)

4. INSTRUCTIONS POUR LE GRIL ENCASTRÉ BIU405N080-0215N570-0026N080-0215N570-0026N715-0083N080-0155N080-015523 e c-cN570-0026Ce gril est conçu pour de

Seite 9

5. INSTRUCTIONS POUR LE BRÛLEUR LATÉRAL ENCASTRÉN280-0003P (NOIR)N280-0004 (ACIER INOX.)l. Placez le cadre du brûleur latéral dans l’ouverture. Le cad

Seite 10

6. INSTRUCTIONS D’INSTALLATION DES TIROIRS7. INSTRUCTIONS D’INSTALLATION DES PORTES1. Déballez le cadre et la porte.a. Pour les portes cambrées en ac

Seite 11 - MATÉRIAU INCOMBUSTIBLE

BIPT450 29 1/2” 20 5/8” 8 7/8”BIPT600 37 3/4” 20 5/8” 8 7/8”BIPT750 49 3/4” 20 5/8” 9 5/8”BIU405 271/2” 16 3/4” 12

Seite 12 - SUR LES QUATRE CÔTÉS

HWDNOTE: ACCESSORY FRAMES OVERLAPOPENING BY 1 ½” ON ALL 4 SIDESPart #DescriptionPictureWHN370-0070Flat horizontal painted doorN370-0357SSN370-0358SS13

Seite 13

1. BIPT450 BUILT-IN INSTRUCTIONSThis grill is designed for MASONRY, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a qualified

Seite 14

2. BIPT600 BUILT-IN INSTRUCTIONSThis grill is designed for MASONRY, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a qualified

Seite 15

3. BIPT750 BUILT-IN INSTRUCTIONSThis grill is designed for MASONRY, NON-COMBUSTIBLE enclosures only, and must be installed and serviced by a qualified

Seite 16 - 23 e c-c

4. BIU405 BUILT-IN INSTRUCTIONSN080-0215N570-0026N080-0215N570-0026N715-0083N080-0155N080-015523 e c-cThis grill is designed for MASONRY, NON-COMBUST

Seite 17 - N280-0004 (ACIER INOX.)

1. Fit the side burner frame into the opening. The frame should be attached to the opening to prevent any future movement (fasten-ers not included).2

Seite 18

6. BUILT-IN ACCESSORY DRAWER INSTRUCTIONS7. BUILT-IN ACCESSORY DOOR INSTRUCTIONS1. Unpack the drawer frame assembly.2. Remove the drawers from the enc

Kommentare zu diesen Handbüchern

Keine Kommentare

Napoleon Grills Gourmet Grill Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Barbrque & Grills Napoleon Grills Gourmet Grill herunter. Napoleon Grills Gourmet Grill User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Barbrque & Grills Napoleon Grills Gourmet Grill